Skip to content

Receiving Samples at the Lab

When a sample arrives at the laboratory, the receiving technician scans the barcode and formally accepts it into the lab's workflow. This step is important: it records the time of receipt, confirms the sample is fit for testing, and makes the investigation visible on the analyst's worklist. If a sample is unfit, it can be rejected at this stage.


Before You Begin

  • The sample must have been collected and labelled with a barcode sticker. Status should be Sample Collected (or Sample Sent, if it was transported from another location).
  • You need the LabSampleCollecting or LabSampleReceiving privilege to see Lab → Sample Management. Ask your system administrator if you cannot open it.

Receiving a Sample

  1. Go to Lab → Sample Management.
  2. Set the filters, such as the From Date and To Date, the sample type (All Samples, Internal Samples Only or Outsource Samples Only) and the patient type, then search.
  3. Find the samples in the Samples list. You can search by Sample Id, which is printed on the barcode.
  4. Inspect each sample. Tick the ones that are acceptable (correct volume, no haemolysis, correct container, intact label).
  5. Click Received Samples. The system records the time and your name, and the investigations become ready for testing.

To collect and receive in one step, for example when the sample is taken in the lab itself, tick the samples and click Collect & Received Samples.


Rejecting a Sample

Reject a sample that does not meet quality standards, for example one that is haemolysed, clotted, unlabelled, in the wrong tube, too small or delayed in transit.

  1. In Lab → Sample Management, tick the samples.
  2. Enter the Sample Reject Reason. The system will not reject a sample without a reason.
  3. Click Reject Samples.

A sample cannot be rejected if its bill is cancelled, its investigation has been refunded, or it is already rejected or sent to another lab. To ask for a new sample, use Request Re-Collect Sample. See Sample Rejection & Recollection.


Taking Back a Sample Sent to the Lab

If a sample was sent to the lab by mistake, tick it, enter the Sample Retrieving Reason and click Retrieving the sent sample.


Receiving Many Samples at Once

Tick every acceptable sample in the list, then click Received Samples once. All ticked samples are received together.


What Happens After Acceptance

  • The investigation appears on the worklist for the relevant analyst or analyzer.
  • For automated tests, the middleware will query the system and collect the test order; results will return automatically once the analyzer completes the run.
  • For manual tests, the analyst searches for the investigation in the report entry screen and enters results.

Tips and Best Practices

  • Always scan the barcode rather than searching manually — scanning is faster and eliminates transcription errors.
  • If the barcode will not scan (damaged or smudged sticker), search by patient name and bill number, then verify visually before accepting.
  • Haemolysed samples should be rejected and recollection requested even if the volume is adequate — haemolysis affects many biochemistry results.
  • Maintain a rejection log for quality audit purposes. The system records all rejections with a timestamp and the receiving technician's identity.

Back to LIMS